hi there i have been viewing this forum for a while now and decided to get myself a prusa i3 kit
i have built it with no problems but now i am stuck on the software configuration side
i brought the standard kit from replicatorwarehouse.com with these bits inlcuded
•All Printed parts (with all the best upgrades)
•Aluminium frame for SC10UU
•Bolts and nuts, bearings and linear bearings lm8uu and sc10uu, metal couplings, threaded and smooth rods.
•5 NEMA17 stepper motors with 1m cables and molex plugs.
•All in one electronics set what includes Arduino mega 2560, ramps 1.4, Heated Bed, SD card reader and LCD panel, cables, endstops.
•Arcol.hu extruder kit + hobbed bolt
•GT2 Belts and aluminium pulleys.
•Laptop chargers 12V 5A, 10A,
now could someone please help me to configure marlin software for it, i have asked them for advice but they only have a out of date marlin firmware which i have and it does not drive it properly
any help would be much aprecieated
i have built it with no problems but now i am stuck on the software configuration side
i brought the standard kit from replicatorwarehouse.com with these bits inlcuded
•All Printed parts (with all the best upgrades)
•Aluminium frame for SC10UU
•Bolts and nuts, bearings and linear bearings lm8uu and sc10uu, metal couplings, threaded and smooth rods.
•5 NEMA17 stepper motors with 1m cables and molex plugs.
•All in one electronics set what includes Arduino mega 2560, ramps 1.4, Heated Bed, SD card reader and LCD panel, cables, endstops.
•Arcol.hu extruder kit + hobbed bolt
•GT2 Belts and aluminium pulleys.
•Laptop chargers 12V 5A, 10A,
now could someone please help me to configure marlin software for it, i have asked them for advice but they only have a out of date marlin firmware which i have and it does not drive it properly
any help would be much aprecieated