Hi all, is there any precondition for printing, so if temperature of hot end or bed isn't reported to the board, it won't start the print?
(Reason for asking: I know my cable has to be sorted out, so there is no hot end temperature until tomorrow morning and printing is being refused by Mr Ormerod for now)
Which interface are you guys using to start a print, Web UI, PronterFace or any other?
(Reason for asking: I know my cable has to be sorted out, so there is no hot end temperature until tomorrow morning and printing is being refused by Mr Ormerod for now)
Which interface are you guys using to start a print, Web UI, PronterFace or any other?