I was wondering the best way to release prints from the kapton tape. A tall print is quite easy, just tap it with a small hammer and it comes away no problem.
When it comes to low prints like the large extruder cog, I try to prise the print off but always damage the tape, any suggestions on how to remove the print without damaging the tape. I also use PVC cement, works great, but again difficult to release low prints.
John
Omerod 096
When it comes to low prints like the large extruder cog, I try to prise the print off but always damage the tape, any suggestions on how to remove the print without damaging the tape. I also use PVC cement, works great, but again difficult to release low prints.
John
Omerod 096