Hi folks,
I modified my printer's z-axis, it is now 450 mm long. In Repetier I set the z-axis value to 450 mm. When I try to steer the z-axis motor to a value larger 220 mm (either by manual control or when printing) the motor stops at 220 mm. There are definitely no mechanical issues that could be the reason. Also when homing the z-axis after it hit the limit of 220 mm the stepper makes stuttering noises until it touches the end stop switch. Then everything works fine again.
Can someone try this and confirm? Any solutions?
Thanks!
Hugo
I modified my printer's z-axis, it is now 450 mm long. In Repetier I set the z-axis value to 450 mm. When I try to steer the z-axis motor to a value larger 220 mm (either by manual control or when printing) the motor stops at 220 mm. There are definitely no mechanical issues that could be the reason. Also when homing the z-axis after it hit the limit of 220 mm the stepper makes stuttering noises until it touches the end stop switch. Then everything works fine again.
Can someone try this and confirm? Any solutions?
Thanks!
Hugo