I have a problem setting up my printer (commissioning)
I can not home x nor Z
I get 0 out of the Z-probe (using G31).
For a short while I had a readout (app 500) just after flashing the firmware from 0.57 to 0.57a, and now nothing.
I doublecheccked (trible and more) wiring it all appears to be ok, and is untouched from the small moment it worked.
Any suggestions for troubleshooting ?
Context:
Ormerod: green
Firmware: 0.57a.
Axis moves (correct directions, homing Y is ok).
Pronterface will not connect unless I send "M555 P2" from Arduino first.
WWW not working at all (IP set to 192.168.11.113, gateway to 192.168.11.1 on private LAN).
Duet driven by PSU (jumper) but everything tested powered by PC with no change.
I can not home x nor Z
I get 0 out of the Z-probe (using G31).
For a short while I had a readout (app 500) just after flashing the firmware from 0.57 to 0.57a, and now nothing.
I doublecheccked (trible and more) wiring it all appears to be ok, and is untouched from the small moment it worked.
Any suggestions for troubleshooting ?
Context:
Ormerod: green
Firmware: 0.57a.
Axis moves (correct directions, homing Y is ok).
Pronterface will not connect unless I send "M555 P2" from Arduino first.
WWW not working at all (IP set to 192.168.11.113, gateway to 192.168.11.1 on private LAN).
Duet driven by PSU (jumper) but everything tested powered by PC with no change.