Hi,
I have just got a new hotend built which is a little longer than the previous one, and I am unable to get slicer to change the point at which it thinks the bed is.
It continually tries to go past the bed (have removed it for calibration).
My firmware has got its own offset, is this overriding it, is it a bug (fixed in RC2?) or am I doing something wrong? I have tried many different offset numbers, positive and negative but there is no difference in its behaviour.
cheers muchly for any help!
Rich
I have just got a new hotend built which is a little longer than the previous one, and I am unable to get slicer to change the point at which it thinks the bed is.
It continually tries to go past the bed (have removed it for calibration).
My firmware has got its own offset, is this overriding it, is it a bug (fixed in RC2?) or am I doing something wrong? I have tried many different offset numbers, positive and negative but there is no difference in its behaviour.
cheers muchly for any help!
Rich
