Hi,
still not successful printing with 0.12mm layer after some time now, rayhicks and I were chatting about different reasons for the unusual behaviour when going lower than 0.24mm.
In this thread there is some more insight, the findings and the workaround rayhicks suggested. So with this workaround printing in 0.12mm is now possible - here a comparison of my first successful print in 0.12mm. There are still some settings to tweak (overextrusion, temperature, retraction length) but at least it works.
Overview (left 0.24mm, right 0.12mm):
![]()
Direct comparison
![]()
Markus
P.S. I started a new thread to compare photos from different users in 0.12mm rather than digging into details about the firmware/ hardware issues which can be done in the other thread.
still not successful printing with 0.12mm layer after some time now, rayhicks and I were chatting about different reasons for the unusual behaviour when going lower than 0.24mm.
In this thread there is some more insight, the findings and the workaround rayhicks suggested. So with this workaround printing in 0.12mm is now possible - here a comparison of my first successful print in 0.12mm. There are still some settings to tweak (overextrusion, temperature, retraction length) but at least it works.
Overview (left 0.24mm, right 0.12mm):
Direct comparison
Markus
P.S. I started a new thread to compare photos from different users in 0.12mm rather than digging into details about the firmware/ hardware issues which can be done in the other thread.