Hey guys, just installed bluetooth and it works really well. The only problem is that I still need to plug it in to power ramps, and I'm worried that I'm going to fry it if I go ahead and just try things! The instructions are all too unclear on the RAMPS page.
If I want to solder D1, do I need a diode or can I just use a small piece of wire? Also if I don't do D1, how do I use the little connections next to the reset button?! Can I just jump D1 with a piece of wire and call it good?
I just need to know the best, simplest way of doing this without needing to order a diode. I'm good at soldering, that won't be a problem.
Thanks!!
If I want to solder D1, do I need a diode or can I just use a small piece of wire? Also if I don't do D1, how do I use the little connections next to the reset button?! Can I just jump D1 with a piece of wire and call it good?
I just need to know the best, simplest way of doing this without needing to order a diode. I'm good at soldering, that won't be a problem.
Thanks!!