ok so ive got a pelt unit, when you run it with 12v you get side one cold side 2 hot, if you reverse the wiring side 1 hot side 2 cold. i have a switch with 1 pole and three throws, so it has three pins if the switch is in position one it connects pin 1 and 2, if its in position two pin 2 is disconnected, in position 3 pin 2 and 3 are connected. if I connect the positive wire of the pelt unit to +12v and the negative wire of the pelt to pin 2 on the switch, will connecting ground to pin one of the switch and +24v to pin 3 give me + and - 12v through the pelt unit? also will it take the same watts to run it either way? i can make a diagram if it helps, my main concern is that running the pelt between the +12v and +24v with use more watts than between gnd and +12v, although in theory it shouldn't
↧