Ok the following even though 5V is not attached (power supply isn't either) when I connect the pcb to my usb serial convertor it lights up the standby led
and if I connect an atx power supply even though the atx jumper is the one jumpered the power led lights up and that shouldn't do this unless the psu turns on.
made some changes to the board but that was only to save a few resistors and jumpers and it shouldn't cause this.
please take a look and give me hints where I should be looking for the short.
Regretably I have no digital camera right now or I would blow up a photo and look for it that way
Help
terramir
[attachment 15407 Gen7Board1.4.1lc.png]
[attachment 15408 Gen7_Board_1.4.1_Layout.png]
and if I connect an atx power supply even though the atx jumper is the one jumpered the power led lights up and that shouldn't do this unless the psu turns on.
made some changes to the board but that was only to save a few resistors and jumpers and it shouldn't cause this.
please take a look and give me hints where I should be looking for the short.
Regretably I have no digital camera right now or I would blow up a photo and look for it that way
Help
terramir
[attachment 15407 Gen7Board1.4.1lc.png]
[attachment 15408 Gen7_Board_1.4.1_Layout.png]
