Hello there.
Today I started to prepare my GEN6 deluxe Board for the Repetier Firmware 0.83.
During compilation I realized that there is something missing. "#include " So I tried as first to comment this part out. I did this in "Repetier.pde" and "Commands.cpp".
The result massage was:
Binary sketch size: 58182 bytes (of a 63488 byte maximum)
avrdude: verification error, first mismatch at byte 0xe000
0x80 != 0xff
avrdude: verification error; content mismatch
Do somebody knows problems like that? Is the ZIP-File not complete?
It would be were kindly if you could help me.
I try to run m hole system via Repetier, but till now I am face with problms.
Greetings
Rudi
Today I started to prepare my GEN6 deluxe Board for the Repetier Firmware 0.83.
During compilation I realized that there is something missing. "#include " So I tried as first to comment this part out. I did this in "Repetier.pde" and "Commands.cpp".
The result massage was:
Binary sketch size: 58182 bytes (of a 63488 byte maximum)
avrdude: verification error, first mismatch at byte 0xe000
0x80 != 0xff
avrdude: verification error; content mismatch
Do somebody knows problems like that? Is the ZIP-File not complete?
It would be were kindly if you could help me.
I try to run m hole system via Repetier, but till now I am face with problms.
Greetings
Rudi