I have Nophead's kit.
I managed to break off the USB header, soldered it back on but now it is failing to be recognized by USB again. I just get "unable to enumerate USB device" no matter what cable, USB port or computer I use. This time I didn't rip it off, but it might be getting loose and I'm afraid that with my poor soldering skills it might not be repairable.
I'm going to try to re-solder it back on, but if I don't manage then what do I need to do to replace the board? I assume this is the same board that came with the kit:
[www.sainsmart.com]
Once I get this fixed again (whether by solder or a new board) I'm going to pin the USB cable to the frame so that there's no force pulling on the board.
Thanks.
I managed to break off the USB header, soldered it back on but now it is failing to be recognized by USB again. I just get "unable to enumerate USB device" no matter what cable, USB port or computer I use. This time I didn't rip it off, but it might be getting loose and I'm afraid that with my poor soldering skills it might not be repairable.
I'm going to try to re-solder it back on, but if I don't manage then what do I need to do to replace the board? I assume this is the same board that came with the kit:
[www.sainsmart.com]
Once I get this fixed again (whether by solder or a new board) I'm going to pin the USB cable to the frame so that there's no force pulling on the board.
Thanks.
