I have all my steppers pretty close to perfect accept my extruder. Whenever it's under any extra load it just start shimmering not turning. I understand that this happens when you have your current too low on your driver, but when I turn mine up it either stops or whines and stops. If dial it back it will sometimes turn the motor but even if starts turning it will quickly stop turning....
it's a Wade's extruder on a prusa mendel v2
1.8 degree 200 step
any idea? turn up the temp? the hot end is running about 195 C with PLA
it's a Wade's extruder on a prusa mendel v2
1.8 degree 200 step
any idea? turn up the temp? the hot end is running about 195 C with PLA