Hi there, I'm building my own printer, and everything goes reasonably well, but....
My Z-axis behaves strangely.
After starting a printjob, all axis go to their home position, and for the z-axis that is all the way up.
works fine until the next step, after homing on Z, my heated bed starts to go down, moving far away from my printhead.
I am building a simple cartesian printer, using a ramps board, and repetier firmware.
Can anybody help me trough this?
Rien.
My Z-axis behaves strangely.
After starting a printjob, all axis go to their home position, and for the z-axis that is all the way up.
works fine until the next step, after homing on Z, my heated bed starts to go down, moving far away from my printhead.
I am building a simple cartesian printer, using a ramps board, and repetier firmware.
Can anybody help me trough this?
Rien.