Hi Guys,
I wondered if I can pick your brains. I have installed a new extruder with 0.4mm nozzle to my printer. I am trying to print a single wall box out of ABS. I got to the point where it prints the box but the corners seem to collapse (you can see ont he photo that these are pretty much missing)
At the moment the settings are as follows
temp extruder: 245C first layer/ 235 thereafter
temp bed: 115 first layer/110 after
print speed 8mm/s firs layer/ 16mm/s for perimeters later
layer height 0.3mm
It almost looks like it is stopping and starting in the corner. Hope you can help here.
Kind regards
Pawel
I wondered if I can pick your brains. I have installed a new extruder with 0.4mm nozzle to my printer. I am trying to print a single wall box out of ABS. I got to the point where it prints the box but the corners seem to collapse (you can see ont he photo that these are pretty much missing)
At the moment the settings are as follows
temp extruder: 245C first layer/ 235 thereafter
temp bed: 115 first layer/110 after
print speed 8mm/s firs layer/ 16mm/s for perimeters later
layer height 0.3mm
It almost looks like it is stopping and starting in the corner. Hope you can help here.
Kind regards
Pawel