Hi all,
After having printed successfully 2 androids, I am having serious adhesion issues. First layer is not sticking at all to the glass.
I am trying several solutions : acetone, alcool, dish washing liquid, etc... but every unsuccessful trial causes a mess of plastic that takes me a long time to clean before the next trial.
So I am looking for an emergency stop command that would not require homing again etc... That would enable me to be much more efficient by saving time inbetween two trials.
I have tried the M0 or M112 command, but nothing happens.
Is there a better solution than abruptly shutting down the machine ?
After having printed successfully 2 androids, I am having serious adhesion issues. First layer is not sticking at all to the glass.
I am trying several solutions : acetone, alcool, dish washing liquid, etc... but every unsuccessful trial causes a mess of plastic that takes me a long time to clean before the next trial.
So I am looking for an emergency stop command that would not require homing again etc... That would enable me to be much more efficient by saving time inbetween two trials.
I have tried the M0 or M112 command, but nothing happens.
Is there a better solution than abruptly shutting down the machine ?