Hi All,
I'm working on a project where I'd like to have a constant 12V output from the extruder outputs on the RAMPS 1.4 board during extrusion events. I'm currently trying to sift through the Marlin firmware to determine how much work is going to be involved to modify for my needs, and it seems as though it may be easier to write "add-on" code in place of trying to modify the existing stepper functions to output a constant 12V during the extrusion events on only the E0 / E1 outputs.
Is there any firmware that exists that accomplishes this already?
Thanks,
zip
I'm working on a project where I'd like to have a constant 12V output from the extruder outputs on the RAMPS 1.4 board during extrusion events. I'm currently trying to sift through the Marlin firmware to determine how much work is going to be involved to modify for my needs, and it seems as though it may be easier to write "add-on" code in place of trying to modify the existing stepper functions to output a constant 12V during the extrusion events on only the E0 / E1 outputs.
Is there any firmware that exists that accomplishes this already?
Thanks,
zip