If I have my Z height set in firmware so that objects sliced with Skeinforge have the perfect "squish" on the first layer (and the walls go up exactly straight right from layer one) the first layer of objects sliced with Slic3r will be too "squished" and the walls will go up unevenly with the base being wider than the middle and top of the print.
Is there a way to fix this other than changing Z height in firmware each time I switch slicers? Thanks in advance to anyone who could start me pointed in the right direction.
Is there a way to fix this other than changing Z height in firmware each time I switch slicers? Thanks in advance to anyone who could start me pointed in the right direction.