Re: PLA filament Jam
The following condition would be caused by PLA filament Jam
A) flow rate set too large, causing the filament feed speed is faster than the flow rate.
B) the material thermal expansion caused by the filament jam,This phenomenon occurs when the use of a high probability of PLA.
C) The PLA can be printed between 170C~230C and the idea is 210C. This value will little variable due to different color and printer temperature sensor
The 3D printer filament -ABS/PLA/HIPS/NYLON/PC/PETG/POM - -www.lifeng-indust.com ,have competetive cost.
The following condition would be caused by PLA filament Jam
A) flow rate set too large, causing the filament feed speed is faster than the flow rate.
B) the material thermal expansion caused by the filament jam,This phenomenon occurs when the use of a high probability of PLA.
C) The PLA can be printed between 170C~230C and the idea is 210C. This value will little variable due to different color and printer temperature sensor
The 3D printer filament -ABS/PLA/HIPS/NYLON/PC/PETG/POM - -www.lifeng-indust.com ,have competetive cost.