I hate to do this, but I'm sick of it. I bought a kit from SeeMeCNC in February, 2013. I finished building the printer in mid June. I have only 170 hours on the printer, but I had an issue with the original power resistors (shorted the thermistor), so I installed a new cartridge heater and a fresh thermistor.
It's built, it works, but I can't for the life of me get it properly calibrated. The bed doesn't appear to be fully level (about 150-200 micron variation from left to right side), and my delta arms are a bit sticky. These are not disasterous impossible items to fix, but frankly, I'm tired of this bullcrap. I'm tired of fixing this thing.
I'm looking to sell my Rostock MAX so I can fund buying a pre-assembled printer.
I'm asking for best offers (PM me please), and would prefer local pickup (Wilmington, Delaware), but can arrange shipping for an additional price (I have an expanding foam machine at work I could possibly use to pack the unit).
Complete build log photos are available here: [www.flickr.com]
It's built, it works, but I can't for the life of me get it properly calibrated. The bed doesn't appear to be fully level (about 150-200 micron variation from left to right side), and my delta arms are a bit sticky. These are not disasterous impossible items to fix, but frankly, I'm tired of this bullcrap. I'm tired of fixing this thing.
I'm looking to sell my Rostock MAX so I can fund buying a pre-assembled printer.
I'm asking for best offers (PM me please), and would prefer local pickup (Wilmington, Delaware), but can arrange shipping for an additional price (I have an expanding foam machine at work I could possibly use to pack the unit).
Complete build log photos are available here: [www.flickr.com]