[attachment 22222 RAMBOCircles.JPG]I have had a RANBO 1.1b configured and running for a couple of weeks on a MendelMax1.5
It ran great for couple of weeks. I was printing ornaments and peace signs and they were printing great.
Last knight I ran some peace signs and the circles which were printing great are now printing with a slight irregularity which is messing up the entire print.
I checked all of the mechanics and everything is smooth. I tried printing on different sections of the bed and still the same.
I re-flashed the firmware and still the same.
I tried varying the Slic3r setting and still no change.
I checked the belts tension and the belts seem OK.
No changes were made to the Marlin config which worked great fro a couple of weeks and a lot of prints.
Then problem is repeatable and consistent. Pretty much the same regardless of size.
Any ideas?
It ran great for couple of weeks. I was printing ornaments and peace signs and they were printing great.
Last knight I ran some peace signs and the circles which were printing great are now printing with a slight irregularity which is messing up the entire print.
I checked all of the mechanics and everything is smooth. I tried printing on different sections of the bed and still the same.
I re-flashed the firmware and still the same.
I tried varying the Slic3r setting and still no change.
I checked the belts tension and the belts seem OK.
No changes were made to the Marlin config which worked great fro a couple of weeks and a lot of prints.
Then problem is repeatable and consistent. Pretty much the same regardless of size.
Any ideas?