Hi. I'm building a reprappro mendel using the instructions here.
In the instructions it says to arrange 8 wires in the ribbon cable like this:
1. Wire with the colour stripe: Thermistor
2. Thermistor
3. Fan + volts
4. Fan Ground
5. Heater resistor Wire 1
6. Heater resistor Wire 1
7. Heater resistor Wire 2
8. Heater resistor Wire 2
I assumed that meant two ribbon cable wires would be crimped onto each end of the resistor, but as far as I can tell all the pictures in the instructions only show one. Any advice on what to do?
In the instructions it says to arrange 8 wires in the ribbon cable like this:
1. Wire with the colour stripe: Thermistor
2. Thermistor
3. Fan + volts
4. Fan Ground
5. Heater resistor Wire 1
6. Heater resistor Wire 1
7. Heater resistor Wire 2
8. Heater resistor Wire 2
I assumed that meant two ribbon cable wires would be crimped onto each end of the resistor, but as far as I can tell all the pictures in the instructions only show one. Any advice on what to do?