Hi everyone. I'm using Sanguinololu Rev 1.3a and Sprinter firmware. Everything alright until one step driver was broken. I have an extra stepping driver and here it is [www.aliexpress.com]
I'm planning to re-use it but it seems small trouble. Sprinter firmware control the board to generate a very narrow pulse width signal. So my m542H can't see and the stepped motor dont rotate. Anyone help me to config the firmware to make they both work together please. Thank you.
I'm planning to re-use it but it seems small trouble. Sprinter firmware control the board to generate a very narrow pulse width signal. So my m542H can't see and the stepped motor dont rotate. Anyone help me to config the firmware to make they both work together please. Thank you.