Help! My Z axis are homing in the wrong direction! (2 replies)

Hey guys!
I'm relatively new to this, so please forgive any grievous mistakes I may make in this post. So basically I have a scaled up mendelmax that's running on Marlin V1 and Pronterface. It's using an arduino mega 2560 with ramps 1.4 and pololu drivers. My problem is that for some reason the Z axis is homing downwards instead of up towards the endstop. In the Config.h I set the value to 1 which is max position I believe. I've looked through various forums and have tried all the solutions but for some reason it doesn't work for me. When I press the negative button in pronterface the Z axis goes down and when I press the positive button it goes up as expected. However whenever I press the home button for the Z axis it goes down. I've tried to set it as -1 for minimum and it still goes down (kinda expected it too but I just found it odd that it did that). Anyways, I have no clue why it's doing that and attached I have my Config.h file if anyone wants to take a look at it. If you need anything clarified or any more information I'd be glad to give it to you to help you help me :)
Thanks,
Jeff
P.S. Please forgive the wordiness haha.