object dimension inaccuracy (1 reply)

hello everyone,

essentially the issue ive been having is that all my parts dimensions are wrong by some margin generally in all directions. the parts im modelling are in solidworks (not sure if this has any effect but i doubt it should do), ive mainly been slicing with slicer as it seems to give stronger structural parts compared to my personally preferred kisslicer, and ive been printing with abs.

im almost certain that the e steps etc are calibrated as spot on as my equipment allows, the inaccuracy in the z axis i believe might be an issue with z home point which i will re calibrate and test.

the inaccuracy's in the other directions i cannot work out.

i can upload images if requested but its essentially on all parts i design.

any ideas as to what i can do to make my prints more accurate will be welcomed.

thanks