Hello, I'm new on this forum.
I'm testing my RAMPS1.4 with 4 motors (X,Y,Z,E) and HotEnd (no HeatBed).
They are working. However, the motors cannot generate sufficient torque.
I thought whether a motor would have a problem, so I connect it to my MEGATRONICS V2 board. As a result, it worked properly.
I can't understand why it doesn't works properly with RAMPS.
motor: Kysan 42BYGH4803-DC
firmware: Marlin
power source: [indimension3.com]
I am glad if someone gives advice. Thanks.
I'm testing my RAMPS1.4 with 4 motors (X,Y,Z,E) and HotEnd (no HeatBed).
They are working. However, the motors cannot generate sufficient torque.
I thought whether a motor would have a problem, so I connect it to my MEGATRONICS V2 board. As a result, it worked properly.
I can't understand why it doesn't works properly with RAMPS.
motor: Kysan 42BYGH4803-DC
firmware: Marlin
power source: [indimension3.com]
I am glad if someone gives advice. Thanks.