i was trying to print this small gear in slic3r and used a lot of different settings and kept getting gaps..... Just for trying i used cura to slice the gear using exactly the same setting as slic3r .... vola much better print...
the one in cura is on the left and the one on the right is done in slic3r 0.9.10b.
layer : 0.25
nozzle 0.4
abs white
perimeter 2
infill 50%
![]()
pic
the one in cura is on the left and the one on the right is done in slic3r 0.9.10b.
layer : 0.25
nozzle 0.4
abs white
perimeter 2
infill 50%
pic