Hi,
I have just completed my printer and tried to begin a print and I have run into some issues.
1.The bed homes to the bottom as it should, but when it brings itself up to the print head it only raises to about halfway and will try to print leaving about 10cm of empty space. I have to then pause the print and manually turn the screw thread up to the correct height.
2. The hotend is now blocked. I have just removed everything and checked and the PEEK part has been welded onto the nozzle and now I think that I have PLA stuck in the nozzle. How can I get the PLA out?
I am totally new at this so any help is appreciated.
Thanks.
I have just completed my printer and tried to begin a print and I have run into some issues.
1.The bed homes to the bottom as it should, but when it brings itself up to the print head it only raises to about halfway and will try to print leaving about 10cm of empty space. I have to then pause the print and manually turn the screw thread up to the correct height.
2. The hotend is now blocked. I have just removed everything and checked and the PEEK part has been welded onto the nozzle and now I think that I have PLA stuck in the nozzle. How can I get the PLA out?
I am totally new at this so any help is appreciated.
Thanks.
