Hello people.
I have been building a printer. After connect all motors , home switch, termistors and nozzle i got it to move all axis manualy.
Then i connect the board to pc and after configured the baud rate and number of stepps for the motors, i got it to comunicate with repetier and make moves over pc. After that i switch it down.
Next time i switch yt on the display seems disconfigured, blank squares but the information remains under. I wasn't abble to move any axis and x drive heats up. Then i removed all drives, and remains.
Now i discover, if power supply via 11A+5A is disconnected and just with the usb connected the lcd works well.
I already change the firmware and it keeps equal.
Somebody can help me with what's wrong.
Best Regards.
I only use one power supply of 24v
I have been building a printer. After connect all motors , home switch, termistors and nozzle i got it to move all axis manualy.
Then i connect the board to pc and after configured the baud rate and number of stepps for the motors, i got it to comunicate with repetier and make moves over pc. After that i switch it down.
Next time i switch yt on the display seems disconfigured, blank squares but the information remains under. I wasn't abble to move any axis and x drive heats up. Then i removed all drives, and remains.
Now i discover, if power supply via 11A+5A is disconnected and just with the usb connected the lcd works well.
I already change the firmware and it keeps equal.
Somebody can help me with what's wrong.
Best Regards.
I only use one power supply of 24v