I just started using Repetier firmware and host to run my Mendel (RAMPS 1.2, Windows 7).
It was printing just fine at first. But now it goes into dry run mode right at the beginning of every print and never actually prints anything. Based on the error it seems like it can only be coming from momentarily high/low temperature readings. I say "momentarily" because the temperature graph doesn't show any obvious peaks or valleys. It does the same thing even when the extruder is already at a stable printing temperature.
I'd rather not turn off the temperature error logic, or work around it by making the high/low artificially wide.
Is there a way to tell Repetier to just wait a few seconds to see if the temperature error repeats instead of turning everything off because of a single isolated anomaly?
It was printing just fine at first. But now it goes into dry run mode right at the beginning of every print and never actually prints anything. Based on the error it seems like it can only be coming from momentarily high/low temperature readings. I say "momentarily" because the temperature graph doesn't show any obvious peaks or valleys. It does the same thing even when the extruder is already at a stable printing temperature.
I'd rather not turn off the temperature error logic, or work around it by making the high/low artificially wide.
Is there a way to tell Repetier to just wait a few seconds to see if the temperature error repeats instead of turning everything off because of a single isolated anomaly?