Hello everyone,
Am having some problems with my sanguino. The endstops don't seem to work they stay in the low configuration. First I thought I might have blown up the ATmega so I ordered another one. Much to me surprise this one had the exact same issue.
So what have I tried so far:
Clean sprinter firmware
measured if SIG is in anyway connected to GND (It isn't)
Bought a new ATmega 1284p
Clean merlin firmware
Bent microcontroller pin so it isn't connected to the board (still low)
I have some basic knowledge of electronics but not enough so solve this issue I hope there is someone that can help me out.
Edit:
The board works perfectly other then the endstops and the X axis going only one way. This isn't my first printboard I have soldered but a mistake is possible, even tough everything pretty much seems to work.
Am having some problems with my sanguino. The endstops don't seem to work they stay in the low configuration. First I thought I might have blown up the ATmega so I ordered another one. Much to me surprise this one had the exact same issue.
So what have I tried so far:
Clean sprinter firmware
measured if SIG is in anyway connected to GND (It isn't)
Bought a new ATmega 1284p
Clean merlin firmware
Bent microcontroller pin so it isn't connected to the board (still low)
I have some basic knowledge of electronics but not enough so solve this issue I hope there is someone that can help me out.
Edit:
The board works perfectly other then the endstops and the X axis going only one way. This isn't my first printboard I have soldered but a mistake is possible, even tough everything pretty much seems to work.
