Hello!
I am putting together an i3 and am printing the parts on my i2. I am not sure why, but when I try to piece together the extruder:
[www.thingiverse.com]
with the standard x carriage (three bearing version), it seems like the screw that holds the idler on (the hinged end at the bottom) wants to hit the x-carriage, which prevents the two pieces from fitting flush together. Am I doing something wrong? If the idler was just a little higher up, it would clear the xcarriage.
Edit: Also, the screws that hold my hot-end in the extruder want to sit between the two pieces, which also makes them not flat against each other. Is this normal?
I am putting together an i3 and am printing the parts on my i2. I am not sure why, but when I try to piece together the extruder:
[www.thingiverse.com]
with the standard x carriage (three bearing version), it seems like the screw that holds the idler on (the hinged end at the bottom) wants to hit the x-carriage, which prevents the two pieces from fitting flush together. Am I doing something wrong? If the idler was just a little higher up, it would clear the xcarriage.
Edit: Also, the screws that hold my hot-end in the extruder want to sit between the two pieces, which also makes them not flat against each other. Is this normal?