Hello everyone, I am new to the 3d printing world and just finished building my Prusa i3 XS'S INK model. Unfortunately, calibration isn't going smoothly as the build. To keep it short and sweet I will list my questions.
1) I started off homing the axis and they all stop at the end stops perfectly but when I say move 200mm it moves only 140mm.
2) For some reason my extruder's temp fluctuates greatly (ie: it goes up to 240 and then down to 190 then up to 240 ect.)
3) I am not getting power to the D9 and D8 ports on RAMPS 1.4
4) When I try to print a 20mm cube it seems like the Z axis doesn't go high enough after each layer and ends up squashing the cube.
5) When I change the settings in slicer and look at the GCODE in pronterface I notice that it doesn't take into account my setting changes and all the numbers in GCODE are the default value. (i.e. change layer height in slicer to .5 it is .4 in the GCODE) and I know I saved the changes because i can open up slicer everytime and see the changes.
I would post the GCODE but its just the default values so it wouldn't help. Thanks in advance.
1) I started off homing the axis and they all stop at the end stops perfectly but when I say move 200mm it moves only 140mm.
2) For some reason my extruder's temp fluctuates greatly (ie: it goes up to 240 and then down to 190 then up to 240 ect.)
3) I am not getting power to the D9 and D8 ports on RAMPS 1.4
4) When I try to print a 20mm cube it seems like the Z axis doesn't go high enough after each layer and ends up squashing the cube.
5) When I change the settings in slicer and look at the GCODE in pronterface I notice that it doesn't take into account my setting changes and all the numbers in GCODE are the default value. (i.e. change layer height in slicer to .5 it is .4 in the GCODE) and I know I saved the changes because i can open up slicer everytime and see the changes.
I would post the GCODE but its just the default values so it wouldn't help. Thanks in advance.
