Hello, and thanks to all:)-D (no replies)

He there!

Just wanted to say thanks to all of you how post here, ( and more probably)

I'm just in the process of calibrating my new prusa i3, and without this forum and its people, i would not have come this far!(tu)

I've been using the Prusa i3 design from Twelvepro on Thingiverse, and have made some modifications of my own,
just because i didn't know anyone with a printer, and i didn't want to buy every single part.

So in short lines, i've started with getting some electronics, since that part i don't know about i've bought a Megatronics v2 set after a lot of reading,
and try to make it do something, and so it turned out, it wasn't so bad at all!

Then on the "Twelvepro Prusa" made some extra laser cuttable parts for the Z carriage? (things that goes up and down) and the extruder carriage, and made it a bit higher and had it laser cut from aluminium at work
(Lucky me! B) )

Some alu angle from the hardware store, rods, small stuff and a a weekend later it had pretty much taken shape!

The bed and extruder, i've also needed to buy.

And now i have my first printer!!! >:D<(:P)
It still needs some adjustment and refinement ;) but i'll get there.....

Here's a short video

Special thanks to:

Josef Prusa
Twelvepro
And everybody who's helping the reprap community!

Ciao!