Hello guys!
First ... please don't laugh! I'm absolutely new to Adurino and co and so have some dummy questions, to get a feeling for this field of engagement.
Regarding the use of supporting PLA material - is there a possibility to control ( offset calibrate) a dual head extruder
either via two separate drivers / powerstages or by switching just the motors on one stage ... its not the neccesity to clarify this down to the part but would I have to take all the existing concept ( software) apart to solve such a thing or would the concept be prepared for in general?
( separating the printing areas for different materials with nozzle offset correction different densities of printing ( break off structure on the PLA)?
THe last point would probably be more a Software question but perhaps someone would know!
Hansjoerg
First ... please don't laugh! I'm absolutely new to Adurino and co and so have some dummy questions, to get a feeling for this field of engagement.
Regarding the use of supporting PLA material - is there a possibility to control ( offset calibrate) a dual head extruder
either via two separate drivers / powerstages or by switching just the motors on one stage ... its not the neccesity to clarify this down to the part but would I have to take all the existing concept ( software) apart to solve such a thing or would the concept be prepared for in general?
( separating the printing areas for different materials with nozzle offset correction different densities of printing ( break off structure on the PLA)?
THe last point would probably be more a Software question but perhaps someone would know!
Hansjoerg