So my printer is built, albeit as a mono unit at this stage and I'm trying to fine tune the results before moving on to the colour side of things. Could you suggest 3 things that improved your printing? Mine are:
- 1) Take your time dialing in the chassis build and then go around again from the start. Fortunatly all the motor cals were already completed before shipment.
2) Next is to use PVA on the glass to get the prints to stick reliably. Not sure I have found the best mix for this yet. I'm using 1:4 PVA to Meths but elsewhere people mention using water. So need to try that.
3) So far the biggest single change to print quality was is to print with a 120mm 3 speed Antec PC fan in front of the bed connected to the fan output on the controller board. As can be seen in the attached picture. Or should I be able to get the print on the right without using a fan?