Hi Community,
Have attached my print of Spocktopus Thing from thingiverse.
This is good example of what iam struggling to figure out.
My prints always start out quite well(i think). The infills good, walls.. but then towards the middle-top it will become botched. Sometimes even sticking back to extruder before forming clumps and back down the print. Also, you can see iam struggling with the finer details - the Spock hand, badge, eyes, brows and even the ears!
What should i try to do. I have tried tweaking many settings in CURA but this is the BEST print i have been able to do. Someone maybe can help me get GOOD quality prints?
I also attached my settings printing this so you can see.
Thanks fellas, hope theres a couple of good souls who can help me out
Have attached my print of Spocktopus Thing from thingiverse.
This is good example of what iam struggling to figure out.
My prints always start out quite well(i think). The infills good, walls.. but then towards the middle-top it will become botched. Sometimes even sticking back to extruder before forming clumps and back down the print. Also, you can see iam struggling with the finer details - the Spock hand, badge, eyes, brows and even the ears!
What should i try to do. I have tried tweaking many settings in CURA but this is the BEST print i have been able to do. Someone maybe can help me get GOOD quality prints?
I also attached my settings printing this so you can see.
Thanks fellas, hope theres a couple of good souls who can help me out