Hey guys,
I'm new to the forum and to programming. I have a gen 2 solidoodle. Currently my extruder is being replaced. I was wondering if there was a way in repetier host to run the x, y, and z motors through g-code. I tried to write a simple program but I can't seem to disable the extruder so that it does it can run without it. Hope that makes sense. Any help would be very.. Well... Helpful. Thanks in advance.
SM
I'm new to the forum and to programming. I have a gen 2 solidoodle. Currently my extruder is being replaced. I was wondering if there was a way in repetier host to run the x, y, and z motors through g-code. I tried to write a simple program but I can't seem to disable the extruder so that it does it can run without it. Hope that makes sense. Any help would be very.. Well... Helpful. Thanks in advance.
SM
