Hey guys, I saw many other topics on this same problem but none with my specific setup. As you know from the title, I'm having trouble getting my filament to stick. I have a Prusa Mendel V2 from MakerFarm. It is setup with a heated bed covered with tempered glass and kapton tape on the glass surface (only in the main print area). My filament is 3mm ABS and the nozzle is .5mm. I use Slic3r (v 8.4) as my settings controler and prontrface for the printer interface. I have attached what my current settings are set at in Slic3r under Printer and Filament. I have also measured what the original home point for the Z axis and it is no higher than a single sheet of paper. What am I doing wrong? Any help would be greatly appreciated.
↧