I recently installed the repetier firmware onto my arduino and when i begin to control it through the Repetier host there are number of things not working or wrong. These are being controlled via the "manual control"
I am running the most recent firmware (Repetier_.83) and host. (V.90c)
x-axis works fine but in reverse
y-axis works fine but in reverse
z- axis only raises, it will not lower towards the bed..
All end stops do not work.
Extruder works but is in reverse.
Heatbed and Nozzle both work as do thermometers.
These problems occur before i have even started to calibrate anything
I am running ramps 1.2 (and i changed the motherboard to "3" as instructed) and an arduino mega 128 on a windows 8 machine.
Any help given would be much appreciated. To let you know I am a complete noobie at this and have little to know skills when it comes to programming or g-code etc..
Many thanks
Paul
I am running the most recent firmware (Repetier_.83) and host. (V.90c)
x-axis works fine but in reverse
y-axis works fine but in reverse
z- axis only raises, it will not lower towards the bed..
All end stops do not work.
Extruder works but is in reverse.
Heatbed and Nozzle both work as do thermometers.
These problems occur before i have even started to calibrate anything
I am running ramps 1.2 (and i changed the motherboard to "3" as instructed) and an arduino mega 128 on a windows 8 machine.
Any help given would be much appreciated. To let you know I am a complete noobie at this and have little to know skills when it comes to programming or g-code etc..
Many thanks
Paul
