Hi Everyone,
I have a Mendel Max 2 with Rumba electronics and cura software. I am having an issue where it will print perfectly for an hour or so and then randomly try to home the X axis so that it just slams into the X endstop and grinds the motors until I unplug it. It is kind of annoying that I have to print for so long to see the effects but I was wondering if anyone else ran into an issue with bizarre homing. I transfer the gcode to an sdcard reader and then tell cura to set the bed temperature via USB but print using the LCD display and the SD card.
Thanks for the help!
I have a Mendel Max 2 with Rumba electronics and cura software. I am having an issue where it will print perfectly for an hour or so and then randomly try to home the X axis so that it just slams into the X endstop and grinds the motors until I unplug it. It is kind of annoying that I have to print for so long to see the effects but I was wondering if anyone else ran into an issue with bizarre homing. I transfer the gcode to an sdcard reader and then tell cura to set the bed temperature via USB but print using the LCD display and the SD card.
Thanks for the help!