There are a couple of movements after I load a sliced file and Slic3r config along the Z-axis, and I can't figure out where the settings are.
One way to replicate it is to pause the print, manually issue a Z-axis command in Pronterface, and then click "resume." The Z-axis will go back to where it was before I issued the manual commands, or at least try to, with a speed so fast my Z motors can't keep up.
Where is this set? I can't find it anywhere. I have speeds all set at 30 mm/s in the Slic3r config.
One way to replicate it is to pause the print, manually issue a Z-axis command in Pronterface, and then click "resume." The Z-axis will go back to where it was before I issued the manual commands, or at least try to, with a speed so fast my Z motors can't keep up.
Where is this set? I can't find it anywhere. I have speeds all set at 30 mm/s in the Slic3r config.