I built a reprap pro Huxley.
I am using Sprinter as my firmware and slicer with Pronterface.
I just got done calibrating my Extruder head and I went to run my first part, a 10mm test cube.
I ran the stl file, loaded the G code file.
On the bottom of Pronterface it tells me the progress of slices, but nothing moves.
It just keeps telling me my temp settings every few moments, line after line on the right hand side, and the bottom line keeps updating the progress of slices, but nothing is moving?
Any ideas on where to look?
I am using Sprinter as my firmware and slicer with Pronterface.
I just got done calibrating my Extruder head and I went to run my first part, a 10mm test cube.
I ran the stl file, loaded the G code file.
On the bottom of Pronterface it tells me the progress of slices, but nothing moves.
It just keeps telling me my temp settings every few moments, line after line on the right hand side, and the bottom line keeps updating the progress of slices, but nothing is moving?
Any ideas on where to look?