I tried to add some support to an object yesterday and was wondering about the amount of support slicer generated. I used 45° and it seemed to be much more, rather about 90° (so for every part with overhang slicer generated support). After a while I noticed that this didn't change, no matter what value I chose (I tried everything from 0° to 100°) slicer always generated the same amount of support. I tried it with 0.9.8 and everything worked as it should.
Is this a bug? Has anyone else noticed this, too? Or did I miss something?
:S
Is this a bug? Has anyone else noticed this, too? Or did I miss something?
:S