All informative pictures from repetier-host are here (pictures are worth a thousand words):
[imgur.com]
I enabled rafting to test whether or not it can make my PLA stick better (warping issues) and for some odd reason the nozzle on my prusa mendel with a printrboard would always go right underneath the painters tape that I laid down... that got annoying fast after I tried time and time after to try to print it... but I decided to check repetier-host to see whether or not the rafts are being laid down properly... sure enough, it didn't look like it was the proper way to do it.
In the last photo, you can clearly see that slic3r misplaced the layer...
Is this a bug or is there a feature that I'm not aware of to fix this problem?
I was using slic3r 0.9.9... 0.9.10b has the same issue.
Things I have tried and didn't work:
1. Reducing the raft layers to 1
2. remove my startup code entirely
3. played around with the newest release of slic3r
4. googled
[imgur.com]
I enabled rafting to test whether or not it can make my PLA stick better (warping issues) and for some odd reason the nozzle on my prusa mendel with a printrboard would always go right underneath the painters tape that I laid down... that got annoying fast after I tried time and time after to try to print it... but I decided to check repetier-host to see whether or not the rafts are being laid down properly... sure enough, it didn't look like it was the proper way to do it.
In the last photo, you can clearly see that slic3r misplaced the layer...
Is this a bug or is there a feature that I'm not aware of to fix this problem?
I was using slic3r 0.9.9... 0.9.10b has the same issue.
Things I have tried and didn't work:
1. Reducing the raft layers to 1
2. remove my startup code entirely
3. played around with the newest release of slic3r
4. googled