Well, I have my Prusa Mendel. Completed construction, everything went smoothly untill I tried to home the Z axis.
The nozzle is going up, instead of going down. Thing is, when I send a command to go up a few centimeters, it goes up. What could it be? All connections are good, I cannot understand why it has this strange behaviour, it keeps searching for the 0 position up.
The nozzle is going up, instead of going down. Thing is, when I send a command to go up a few centimeters, it goes up. What could it be? All connections are good, I cannot understand why it has this strange behaviour, it keeps searching for the 0 position up.