Folks,
firstly I'd like to thank Engineglue for his awesome Youtube videos for the Reprap build guide - thanks!
Secondly, I'd like to thank everyone on this forum - any problems I've had Ive been able to sort out by reading other peoples posts - thanks!
My problem:
I have printed my calibration cube, it looked good (from my newbie eyes) - can you pass on any guidance.
I then printed out a new X motor mount carriage, as you can see from the photos all is not well - I'm thought belt slipping but did notice any.
Can anyone make any suggestions? I'm using ABS, my heat bed is at temperature, using kapton tape (with ABS glue for adhesion).
Photos here
firstly I'd like to thank Engineglue for his awesome Youtube videos for the Reprap build guide - thanks!
Secondly, I'd like to thank everyone on this forum - any problems I've had Ive been able to sort out by reading other peoples posts - thanks!
My problem:
I have printed my calibration cube, it looked good (from my newbie eyes) - can you pass on any guidance.
I then printed out a new X motor mount carriage, as you can see from the photos all is not well - I'm thought belt slipping but did notice any.
Can anyone make any suggestions? I'm using ABS, my heat bed is at temperature, using kapton tape (with ABS glue for adhesion).
Photos here