Hello!
Here are a few pictures of my newly built Prusa i3. I configured it and buit it from the sources on the Github repository (https://github.com/josefprusa/Prusa3). I am amazed how everything did fit together! The only part which I had to modify is the support of the X idler which was to short when using a 608ZZ bearing. Anyway, I will be changing the idler pulleys when I get smaller bearings.
A big thanks to the community for sharing the design!
![]()
![]()
![]()
![]()
![]()
Here is a vidéo of it printing: [www.youtube.com]
I have not yet mounted the heated bed and I have only been printing PLA on blue (or actually purple) tape. I am already impressed by the quality of the prints!
Cheers!
Franck
Here are a few pictures of my newly built Prusa i3. I configured it and buit it from the sources on the Github repository (https://github.com/josefprusa/Prusa3). I am amazed how everything did fit together! The only part which I had to modify is the support of the X idler which was to short when using a 608ZZ bearing. Anyway, I will be changing the idler pulleys when I get smaller bearings.
A big thanks to the community for sharing the design!
Here is a vidéo of it printing: [www.youtube.com]
I have not yet mounted the heated bed and I have only been printing PLA on blue (or actually purple) tape. I am already impressed by the quality of the prints!
Cheers!
Franck