A question regarding the switch endstops:
Using a RAMP 1.3 board and Ponterface. If I move the bed into one of these stops using the Ponterface controls, it will not allow me to move the bed again (in any direction) until I physically push the bed off of the switch. Is that the intended way of operation?
Using a RAMP 1.3 board and Ponterface. If I move the bed into one of these stops using the Ponterface controls, it will not allow me to move the bed again (in any direction) until I physically push the bed off of the switch. Is that the intended way of operation?
