hello everyone,
ive been having an issue with the extruder of the dibond mendel90 nophead supplies, the extruder will be able to halfway through a print of atleast get past the first layer and then the extruder starts to skip every so often, and its getting to the point every other print im having to retract my filament and reinsert it to get it to print again as it will start a print and just skips, its as if its getting blocked every print, im pretty sure the temp is correct.
everything is calibrated to the very best i can do with what i have so i know everything is level etc.
does anyone know of any reason that could cause this kind of issue.
ive been having an issue with the extruder of the dibond mendel90 nophead supplies, the extruder will be able to halfway through a print of atleast get past the first layer and then the extruder starts to skip every so often, and its getting to the point every other print im having to retract my filament and reinsert it to get it to print again as it will start a print and just skips, its as if its getting blocked every print, im pretty sure the temp is correct.
everything is calibrated to the very best i can do with what i have so i know everything is level etc.
does anyone know of any reason that could cause this kind of issue.
